batte melt pump

Method of using loss in weight feeder

1. The loss in weight feeder can not be placed on top of the machine when it is running, because it will burn out the motor because the pressure is too great. If there is, be sure to clean it up in time and start the machine again. 2. Some powder materials cause a large amount of dust to accumulate in the control box of the loss in weight feeder . In the long run, the internal circuit will be short-circuited and the electrical appliances and other parts will be damaged. Therefore, dust in the co

How to prevent the loss of weight loss feeder

Weight loss feeders are suitable for plastics, powders, calcium carbonate, talcum powder, resin film powders, flours, starches, etc., where different raw materials are used. However, the use of a long time, weight loss feeder failure is inevitable, such as loss of weight feeder is one of the common faults. So, what are the reasons for loss of gravity feeders ? How to solve it? Solution: 1. For longer single-tube screw feeders , a gradually increasing pitch can be adopted to prevent the feeder fr

How to use loss in weight feeders

1. When the loss in weightfeeder is started, it cannot be put on the top because it will burn the motor because the pressure on the motor is too high. Therefore, it is necessary to check each time you start the weightless feeder. See if there is something above. If so, be sure to clean it up before starting the machine. 2. Some powdery materials can accumulate a lot of dust in the control box of loss-in-weight feeders . In the long run, it will cause short circuits in internal circuits and damag

Weight loss feeder working principle and application

Lost in weight feeder s working principle is very simple, mainly for the plate feeder is powered by the motor, through the reducer and drive sprocket device, driving the chain plate device for continuous and low-speed continuous motion, to achieve the purpose of transporting materials. Weight loss feeders have many important parts for processing and riveting parts, so there are often some manufacturing quality problems. The average user does not pay attention to it in a timely manner at the init

coating film die lamination film die

coating film die lamination film die . In the cast film die lip can be continuous non-blocking flow surface, with a small interval of the push-pull adjustment screw on the resin pressure and metal up and down bounce effect, bending the flexible lip can be adjusted to die gap. The surface of all hard chrome plated, fasteners using 12.9 high strength bolts, high quality, durable stainless steel heating rods partition heating control. Coating film die lamination film die production is stable, simpl


Chat live
E-mail:sales@battemachinery.com
WhatsApp: +86 158 38331071
Tel: +86 371-67991755
Fax:+86 371-67993277
http://www.loss-in-weightfeeder.com
24h services
batte melt pump

More about screen changer products:

Twin screw loss in weight feede

Micro loss in weight metering f

Single screw loss-in-weight fee

Micro loss-in-weight feeders

Twin screw loss in weight meter


©2019 Batte Mechanical Zhengzhou Co,.Ltd. All rights reserved. sales@battemachinery.com
Batte is a professional screen changer manufacturer, supplying screen changer, especially screen changer for extrusion mould